Best Sundown Audio 10

Features

• RMS Power = 500-watts | Xmax = 14mm one-way by 70% BL | Vented magnetic gap
• Vented pole piece with optimized geometry | Black Aluminum 2.5” voice coil former for superior heat dissipation | High Temperature 4-Layer copper voice coil wire
• Spring Loaded Terminals | Stitched-On “Mini-XL” Tinsel Leads to prevent fatigue and failure
• Specifications: DC Resistance (Re): 4.0 Ω | Resonance Frequency (Fs): 32.2 Hz | Equivalent Volume (Vas): 19.4 L | Electrical Q Factor (Qes): 0.38 | Mechanical Q Factor (Qms): 4.76 | Total Q Factor (Qts):0.35 | Force Factor (BL): 20.2 NA | Moving Mass (incl. Air Load) (Mms): 192.0 g | Suspension Compliance (Cms): 0.13 mm/N | Sensitivity: 84.2 dB 1w / 1m
• Box Recommendations: Sealed: 0.5 cu ft | Ported: 1.0 cu ft | Displacement: 0.11 ft^3 | Cutout Diameter: 8-7/8" | Outside Diameter: 10" | Depth: 5 5/8" | Recommended Tuning: 32hz | Recommended Port Area: 16 in^2

Features

• RMS Power: 1000-watts
• High Temperature copper voice coil wire
• Spring Loaded Terminals
• High strength cast aluminum frame
• Optimized for small ported, sealed, & band-pass enclosures

Features

• Sealed Enclosure: 0.5 cu ft
• Ported Enclosure: 1 cu ft
• Recommended Tuning: 35Hz
• Recommended Port Area: 15 sq in
• Mounding depth 4.9"

Features

• *ONLY 1 PIECE OF SUBWOOFER* The Sundown Audio U-10 is a 10-in subwoofer with a 1500 W RMS power rating. It has a 0.6-in long pole-extension motor to keep the coil under control at high levels of excursion. It also has a cast aluminum frame that allows for taller cones that provide enhanced coil stability and increased mechanical excursion capability.

Features

• Sealed Enclosure: 0.5 cu ft
• Ported Enclosure: 1 cu ft
• Recommended Tuning: 35Hz
• Recommended Port Area: 15 sq in
• Mounding depth 4.9"

Features

• Since their introduction in 2017 the Sundown LCS series woofers have been known for their impressive bass response and high levels of dependability. Typical entry level woofers are highly limited in terms of linear excursion, mechanical ruggedness, and thermal performance – these are all aspects that we have taken to the next level in the Sundown LCS series.
• A double stacked magnet structure and an extremely long voice coil allow us to achieve a class-leading linear x-max of 14mm one-way in addition to high mechanical clearances (over 2” peak-to-peak). The large coil combined with gap venting, chamfered pole-piece design, and optimized pole vent give the LCS Series impressive thermal performance. Mechanical stability and durability are addressed via the strong paper cone, rugged foam surround, and a high quality spider with fully tied-on tinsel leads. All major areas of woofer durability have been addressed to the maximum level possible in this category.
• Bottom-line; if you are looking for a great subwoofer option and you have a tight budget the Sundown LCS Series woofers are for you. These woofers have absolutely no frills – simply raw performance for the dollar.

Features

• RMS Power = 500-watts | Xmax = 14mm one-way by 70% BL | Vented magnetic gap
• Vented pole piece with optimized geometry | Black Aluminum 2.5” voice coil former for superior heat dissipation | High Temperature 4-Layer copper voice coil wire
• Spring Loaded Terminals | Stitched-On “Mini-XL” Tinsel Leads to prevent fatigue and failure
• Specifications: DC Resistance (Re): 6.1 Ω | Resonance Frequency (Fs): 33.5 Hz | Equivalent Volume (Vas): 18.8 L | Electrical Q Factor (Qes): 0.43 | Mechanical Q Factor (Qms): 4.39 | Total Q Factor (Qts):0.39 | Force Factor (BL): 23.5 NA | Moving Mass (incl. Air Load) (Mms): 183.7 g | Suspension Compliance (Cms): 0.12 mm/N | Sensitivity: 84 dB 1w / 1m
• Box Recommendations: Sealed: 0.5 cu ft | Ported: 1.0 cu ft | Displacement: 0.11 ft^3 | Cutout Diameter: 8-7/8" | Outside Diameter: 10" | Depth: 5 5/8" | Recommended Tuning: 32hz | Recommended Port Area: 16 in^2

Features

• Sundown Audio X-10 V.3 D2 10" 2000W RMS Dual 2-Ohm X Series Subwoofer Power Handling: RMS = 2000 watts Voice Coil Configuration: Dual 2-ohm Vented magnetic gap Optimized high-velocity pole vent Innovative high-velocity vented frame spacer ring
• Black Aluminum 3” voice coil former for superior heat dissipation High Temperature Round-Wire CCAW voice coil with high-temp black adhesive All Aluminum Coil that is ~30% longer Large aluminum faraday ring (Magnet ID) Spring Loaded Terminals
• Stitched-On Double-XL Tinsel Leads to prevent fatigue and failure Mega-Roll Surround Technology High strength, custom tooled & patented cast aluminum frame Optimized for small ported & band-pass enclosures Recommended Ported Enclosure: 1.50 ft^3
• Displacement: 0.23 ft^3 Depth: 9" Outside Diameter 11.65" Cut-Out: 10.01" Recommended Tuning: 32hz Recommended Port Area: 24in^2 Weight: 58LB
• RE (Ohms) 3.2 FS (Hz) 40.208 VAS (L) 9.352 Qes 0.528 Qms 2.842 Qts 0.445 Le (mH) BL (NA) 21.509 Mms (Grams) 302.089 Cms (uM/N) 51.867 Sens (dB @ 1w/1m) 82.5dB

Features

• RMS Power: 1000-watts
• High Temperature copper voice coil wire
• Spring Loaded Terminals
• High strength cast aluminum frame
• Optimized for small ported, sealed, & band-pass enclosures

Features